Error Codes Canon i-SENSYS MF3010
|
Код ошибки
|
Описание
|
Устранение
|
|
E000
|
Startup failure
|
1. Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
|
|
2. Replace the Fixing Assembly.
|
|
3. Replace the Engine Controller PCB.
|
|
E001
|
Abnormal high temperature
|
1. Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
|
|
2. Replace the Fixing Assembly.
|
|
3. Replace the Engine Controller PCB.
|
|
E003
|
Abnormal low temperature
|
1. Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
|
|
2. Replace the Fixing Assembly.
|
|
3. Replace the Engine Controller PCB.
|
|
E004
|
Fixing heater drive circuit error (200V models only)
|
1. Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
|
|
2. Replace the Fixing Assembly.
|
|
3. Replace the Engine Controller PCB.
|
|
E100
|
Scanner area failure
|
1. Check connectors on the scanner unit.
|
|
2. Replace the scanner unit
|
|
3. Replace the Engine Controller PCB.
|
|
E196
|
ROM read/write error (error in storing setting values in user mode/service mode/ factory mode)
|
When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
|
|
1. Update the firmware of the Main Controller PCB.
|
|
2. Replace the Main Controller PCB.
|
|
E202
|
CIS Unit home position detection error / homeward reading position error
|
When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
|
|
1. Check the connection between the Main Controller PCB and the CIS Unit. (J2)
|
|
2. Replace CIS Unit.
|
|
3. Check the connection between the Main Controller PCB and the Reader Motor (M3). (J11)
|
|
4. Replace the Reader Motor (M3).
|
|
5. Replace the Main Controller PCB.
|
|
E225
|
Insufficient lamp light intensity (The light intensity is at the reference level or below.)
|
When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
|
|
1. Check the connection between the Main Controller PCB and the CIS Unit. (J2)
|
|
2. Replace CIS Unit.
|
|
3. Replace the Main Controller PCB.
|
|
E301
|
Insufficient light intensity at shading
|
When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
|
|
1. Check the connection between the Main Controller PCB and the CIS Unit. (J2)
|
|
2. Replace CIS Unit.
|
|
3. Replace the Main Controller PCB.
|
|
E744
|
System error
|
When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
|
|
1. Replace the Main Controller PCB.
|
|
2. Replace the Engine Controller PCB.
|
